Fancoil controller 0-10 V

Code: EK-HB1-TP

Description

The Ekinex® EK-HB1-TP actuator / controller allows to control a fan coil unit for the ambient air conditioning. The device can perform the function of simple actuator in combination with a KNX room thermostat or that of actuator / controller with acquisition of the temperature value by a KNX room sensor or a probe connected to an analog input.

The device is suitable for 2-pipe hydraulic distribution systems with ON / OFF control of an electrothermal shut-off valve actuator and a fan with brushless motor. The outputs not used to control the fan coil unit can be configured as binary outputs for different applications.

The device is also equipped with 2 inputs freely configurable as analog or digital. The device integrates a KNX bus communication module and is realized for mounting on a standard 35 mm DIN-rail. The device is supplied by the KNX bus and requires an additional 230 Vac power supply to operate.

Technical data

Power supply

•Voltage (loads) 230 Vac 50/60 Hz
•Voltage (electronics) 30 Vdc by KNX bus

Inputs

•2 freely configurable for passive temperature sensors (10 kΩ NTC at 25°C) or as potential-free binary inputs

Outputs

•1 to control a brushless motor driven fan with 0-10 V signal
•1 relay SPST (single pole, single throw) to control an ON / OFF valve (in 2-pipe hydraulic distribution systems)

Delivery

Delivery includes a terminal block for connection to the bus.

Functions / Characteristics

Plastic casing

Frontal programming pushbutton and LED

Connection to bus line with KNX terminal block

Connection of inputs, outputs and 230 Vac power supply with screw terminals

Classification climatic 3K5 and mechanical 3M2 (according to EN 50491-2)

Overvoltage class III (according to EN 60664-1)

Pollution degree 2 (according to IEC 60664-1)

35 mm rail mounting (according to EN 60715)

4 modular units (1 MU = 18 mm)

IP20 protection degree (installed device)

Weight 175 g

Configuration and Commissioning

A detailed description of the parameters can be found in the application manual of the device. Configuration and commissioning require ETS5 or later versions. ETS application program: APEKHB1TP##.knxprod (## = release). Available languages: English, French, German, Italian.