KNX Dimmer 90-230V~50/60Hz

Code: EK-GD2-TP-1-HV

New

Description

KNX bus device with single-channel phase cut dimmer function for light loads, with supply voltage 90-230 Vac at 50/60 Hz. Use in KNX standard home and building automation systems.

NOTE: Loads that can be used with the dimmer can be: incandescent lamps, mains voltage halogen lamps, mains voltage dimmable LED lamps, mains voltage dimmable LED strips, switching power supplies for dimmable LEDs in phase cut. The dimmer cuts phase in trailing edge mode.

Technical Data

Inputs

Supply Voltage90 - 230 Vac 50/60 Hz

Max. Input Current1 A

Outputs

Number of Output Channels1 Channel

Supply Voltage90 - 230 Vac 50/60 Hz

Output Power110 W @110 Vac, 220 W @220 Vac, 230 W @230 Vac

Minimum Load Power1 W

Max. Output Current1 A

Dimming

Dimming ModeTrailing edge dimming mode with open load control (OPEN CIRCUIT) and short circuit on load (SHORT CIRCUIT)

Dimming Range1-100%

Physical Characteristics & Mounting

Operating Temperature-20 °C ... +40 °C

Storage Temperature-40 °C ... +60 °C

Relative Humidity91% non-condensing

Degree of ProtectionIP00

Housing & MountingPlastic casing; flush-mounting box or panel mounting (with supplied accessory)

Weight37 g

Dimensions (WxHxD)53 x 61 x 29 mm

Functions / Features

ON/OFF control and dimming of individual or grouped luminaires

Fade time on and off, minimum and maximum brightness level, linear or logarithmic dimming curve settable from ETS

Soft or instantaneous switching on and off, with settable delay

Configuration of behaviour after power reset, bus ON/OFF, downloading via ETS

Alarm for short circuit, open load and power failure

Auxiliary output function with status indication via KNX

Locking function, forced operation, staircase light, scenes, night, counter and logic functions settable via ETS

Manual operation with membrane button for local ON/OFF testing also in the absence of the KNX bus: short press switches the load on/off, pressing for at least 2 seconds makes the load flash every 1 s approx.

Configuration and Commissioning

A detailed description of the parameters can be found in the application manual for the device. For configuration and commissioning ETS5 or later versions are required. Application program for ETS: APEKGDXTPXHV##.knxprod (## = release version). Screw terminals for KNX bus, control, power supply and LED source.